Stamped concrete contractors in Edgewater start at the Patio/Slab Permit
A backyard slab in Edgewater isn't handled like a house addition. The city has its own Patio/Slab Permit. The application asks for the slab size, the job cost and a survey showing the slab, the drainage and the setbacks. The form also warns against pushing new fill into a drainage easement. And if trees stand in the fill area, they may need a removal permit of their own.
A stamped concrete contractor in Edgewater should walk you through that first, because a stamped patio is just a slab with a pattern pressed in. The pattern doesn't change the paperwork. Find your survey before we visit, and we'll draw the patio on it together. Patterns, color and sealer are on our stamped concrete service page. This page sticks to what changes when the slab goes in Edgewater.
What a stamped patio does to Edgewater's 60 percent impervious cap
In Edgewater's R-1 through R-4 single-family zones, the Land Development Code caps building coverage at 30 percent and impervious coverage at 60 percent. The code's definition of impervious surface names asphalt, brick and wooden surfaces. Your stamped slab might look like brick or slate, but it counts like plain gray concrete. Every square foot goes in the total.
Do the addition before you pick a size. The house, driveway, walks and the new patio all land in that 60 percent. The code does exempt structures under 1,000 square feet of total impervious area per parcel from the stormwater permit, as long as no fill or excavation changes the runoff. A bigger patio, or one that needs fill, can bring in the city's Right of Way/Stormwater/Fill Application. That one holds the first 1/2 inch of runoff on lots under 10,890 square feet and 1 inch on larger lots, in sodded retention areas no deeper than 6 inches.
We bring a tape and a lot sketch to the estimate and run the numbers with you. Cutting a patio down on paper is free. Cutting it down after the city reviews the plan is not.
What we charge as a stamped concrete contractor in Edgewater, run against patio sizes that fit local lots.
| Job | Per sq ft | Typical project | What moves the price |
|---|---|---|---|
| Stamped patio or entry | $12 to $20 | $3,600 to $10,000 for about 300 to 500 sq ft | Pattern, color, sealer and base prep over poorly drained sand |
| 16 by 20 foot patio | $12 to $20 | 320 sq ft: $3,840 to $6,400 | Under $7,500 in price; the exemption is void on any flood hazard lot |
| 20 by 25 foot patio | $12 to $20 | 500 sq ft: $6,000 to $10,000 | Retention rules, easements and tree roots |
| Tear-out of an old slab | adds $1.50 to $3 | 320 sq ft adds $480 to $960 | Slab thickness, roots and haul |
Ranges only. The free written estimate we give you after we see your site is the price you pay. City permit fees are separate.




